Hygienic Tips Installing Gallon Without Anti-Spill Cover

A few days ago I was surprised because it's hard to find a gallon lid on anti spilled.

The anti-spill cover is mounted on the mouth of a gallon bottle which is useful for preventing mineral water from spilling from the bottle when installing the bottle into a water dispenser.

At that time, the anti spilled cap I had broke while pouring the bottle into the dispenser, consequently the water in the bottle remained spilled when I installed the gallon into the dispenser.

I also searched for a new anti-spill cover to a few stalls to a store selling gallon bottles. But the stuff I was looking for did not exist.

Finally I tried to go to my sister's shop that I know never sell this anti-spill cover.

Arriving there, I was disappointed because the goods are not there. My sister said that nowadays people rarely use anti-spill for gallon bottles, they use more practical ways to tear the gallon lid with a knife, then plug it into a dispenser.

 Read Also: 13 Recommendations for the Most Quality Bottom Gallon Dispenser for Home

I went home, and googling on YouTube looking for tutorials on how to install a gallon bottle without anti-spill.

I finally understood, it was very easy to install a gallon without an anti-spill cap.

But from some tutorials on YouTube, many are less concerned about terms of hygiene and health. For the following I share with you how to install a gallon bottle clean and healthy. Good luck....

1. When first receiving a gallon of mineral water (either original factory or refill) open the thin plastic seal first, then wash the entire gallon surface from start to cover, neck, to the bottom of the gallon, then dry.
2. Prepare wet wipes obtained when buying a gallon bottle, wipe the neck of the gallon until the lid with the tissue.
3. Wipe also part of the bowl dispenser, which is where the gallon entry. Use the inside of tissue to wipe, by unfolding tissue. This is necessary because the outside of the tissue has been used to clean the bottle neck.
4. Reopen the tissue folds, see the clean section. Use to wipe the knife.
5. Tear the gallon lid with a knife twice, crossed (+).
6. Lift the bottle with two hands, first hold the bottom of the gallon neck with two hands, then tilt the gallon to the left. Hold the gallon with your left hand so as not to fall (make sure you do not hold the gallon's neck because if it is held then the gallon's neck will be dirty by your hand), move your right hand to the bottom of the gallon.
7. Lift the gallon up toward the dispenser, point the bottle mouth into the center of the dispenser bowl. Then place the bottle perpendicular to the dispenser.